Lantronix 900-510 manual KDC IP Address, KDC Port, Use Ldap

	11: User Authentication
KDC IP Address	Enter the IP address of the Key Distribution Center (KDC).
KDC Port	Port on the KDC listening for requests. Enter an integer with a
	maximum value of 65535. The default is 88.
Custom Menu	If custom menus have been created, you can assign a default
	custom menu to RADIUS users.
Escape Sequence	A single character or a two-character sequence that causes the
	SLB branch office manager to leave direct (interactive) mode. (To
	leave listen mode, press any key.)
	A suggested value is Esc+A (escape key, then uppercase "A"
	performed quickly but not simultaneously). You would specify this
	value as \x1bA, which is hexadecimal (\x) character 27 (1B)
	followed by an A.
	This setting allows the user to terminate the connect direct
	command on the command line interface when the endpoint of the
	command is deviceport, tcp, or udp.
Break	A series of 1-10 characters users can enter on the command line
Sequence	interface to send a break signal to the external device. A
	suggested value is Esc+B (escape key, then uppercase “B”
	performed quickly but not simultaneously). You would specify this
	value as \x1bB, which is hexadecimal (\x) character 27 (1B)
	followed by a B.
Use LDAP	Indicate whether Kerberos should rely on LDAP to look up
	user IDs and Group IDs. This setting is disabled by default.
	Note: Make sure to configure LDAP if you select this option.
Data Ports	The ports users are able to monitor and interact with using the
	connect direct command. U and L denote the PC Card
	upper and lower slots.
Listen Port	The ports users are able to monitor using the connect listen
	command.
Clear Port Buffers	The ports whose port buffer users may clear using the set
	locallog clear command.
Access Outlets	The power outlets users may monitor and configure.

3.In the User Rights section, select the user group to which Kerberos users will belong.

Group

Select the group to which the Kerberos users will belong:

Default Users: This group has only the most basic rights. You can specify additional rights for the individual user.

Power Users: This group has the same rights as Default Users plus Networking, Date/Time, Reboot & Shutdown, and Diagnostics & Reports.

Administrators: This group has all possible rights.

4. Select or clear the checkboxes for the following rights:

SLB™ Branch Office Manager User Guide 160