Lantronix 900-510 manual Global Commands, Click the Apply button to save the settings

	8: Device Ports
Starting SSH Port	Each port is assigned a number for connecting via SSH.
	Enter a number (1025-65535) that represents the first port.
	The default is 3000 plus the port number. For example, if
	you enter 3001, subsequent ports are automatically
	assigned numbers 3002, 3003, and so on.
Starting TCP Port	Each port is assigned a number for connecting through a
	raw TCP connection. Enter a number (1025-65535) that
	represents the first port. The default is 4000 plus the port
	number. For example, if you enter 4001, subsequent ports
	are automatically numbered 4002, 4003, and so on.
	You can use a raw TCP connection in situations where a
	TCP/IP connection is to communicate with a serial device.
	For example, you can connect a serial printer to a device
	port and use a raw TCP connection to spool print jobs to
	the printer over the network.
	Note: When using raw TCP connections to transmit binary
	data, or where the break command (escape sequence) is
	not required, set the Break Sequence of the respective
	device port to null (clear it).

Caution: Ports 1-1024 are RFC-assigned and may conflict with services running on the SLB branch office manager. Avoid this range.

2. Click the Apply button to save the settings.

To set limits on direct connections:

1.Enter the maximum number (1-10) of simultaneous direct connections for each device port. The default is 1.

2.Click the Apply button to save the settings.

To configure a specific port:

1.You have two options:

Select the port from the ports list and click the Configure button. The Device Ports – Settings page for the port displays.

Click the port number on the green bar at the top of each page.

2.Continue with Device Ports – Settings on page 84.

Global Commands

The following CLI commands correspond to the web page entries described above.

SLB™ Branch Office Manager User Guide 83