Lantronix 900-510 manual Method #1 Using the Front Panel Display, Before You Begin

	4: Quick Setup
Method	Description
Front panel LCD	You manually assign the IP address and other basic network,
display and	console, and date/time settings. If desired, you can restore the
pushbuttons	factory defaults.
Serial port login to	You assign an IP address and configure the SLB branch office
command line	manager using a terminal or a PC running a terminal emulation
interface	program to the SLB device’s serial console port connection.

Method #1 Using the Front Panel Display

Before You Begin

Make sure you know:

An IP address that will be unique and valid on your network (unless automatically assigned)

Subnet mask (unless automatically assigned)

Gateway

DNS settings

Date, time, and time zone

Console port settings: baud rate, data bits, stop bits, parity, and flow control Make sure the SLB branch office manager is plugged in to power and turned on.

Front Panel LCD Display and Pushbuttons

With the SLB device powered up, you can use the front panel display and pushbuttons to set up the basic parameters.

Figure 4-1.Front Panel LCD Display and Five Pushbuttons (Enter, Up, Down, Left, Right)

The front panel display initially shows the hostname (abbreviated to 14 letters), total current level, and state of the four outlets.

When you click the right-arrowpushbutton, the SLB device's network settings display. Using the five pushbuttons, you can change the network, console port, and date/time settings and view the firmware release version. If desired, you can restore the factory defaults.

SLB™ Branch Office Manager User Guide 30