14: Command Reference

xferdatasize <Size In Kbytes to Transfer> Default is 1 Kbyte.

Description

Tests a device port by transmitting data out the port and verifying that it is received correctly.

A special loopback cable comes with the SLB branch office manager. To test a device port, plug the cable into the device port and run this command. The command sends the specified Kbytes to the device port and reports success or failure. The test is performed at 9600 baud. Only an external test requires a loopback cable.

diag traceroute

Syntax

diag traceroute <IP Address or Hostname>

Description

Displays the route that packets take to get to a network host:

End Device Commands

set command

Syntax

set command <Device Port # or Name or List> <one or more parameters>

Parameters

slp auth login <User Login>

Establishes the authentication information to log into the SLP power manager attached to the device port.

slp envmon

Displays the environmental status (e.g., temperature and humidity) of the SLP power manager.

slp outletcontrol state <onoffcyclepower> [outlet <Outlet #>]

Outlet # is 1-8 for SLP8 power manager and 1-16 for SLP16 power manager. The outletcontrol parameters control individual outlets.

slp outletstate [outlet <Outlet #>]

Shows the state of all outlets or a single outlet.

slp restart

Issues the CLI command the SLP power manager uses to restart itself.

slp system

Displays system information for the SLP power manager.

Description

Sends commands to (or controls) a device connected to an SLB device port over the serial port. Currently the only type of device supported for this type of interaction is the SLP power manager.

SLB™ Branch Office Manager User Guide

244

Page 244
Image 244
Lantronix 900-510 manual End Device Commands, Diag traceroute, Xferdatasize Size In Kbytes to Transfer Default is 1 Kbyte