Lantronix 900-510 manual Diagnostic Commands, To display a report of network connections

12: Maintenance and Operation

Diagnostic Commands

The following CLI commands correspond to the web page entries described above.

To display the ARP table of IP address-to-hardware address mapping:

diag arp [email <Email Address>]

You can optionally email the displayed information.

To display a report of network connections:

You can optionally email the displayed information.

diag netstat [protocol <alltcpudp>] [email <Email Address>]

To resolve a host name into an IP address:

You can optionally email the displayed information.

diag lookup <Hostname> [email <Email Address>]

To test a device port by transmitting data out the port and verifying that it is received correctly:

diag loopback <Device Port Number or Name>[<parameters>]

Parameters:

test <internalexternal>

xferdatasize <Size In Kbytes to Transfer> Default is 1 Kbyte.

Note: A special loopback cable comes with the SLB branch office manager. To test a device port, plug the cable into the device port and run this command. The command sends the specified Kbytes to the device port and reports success or failure. The test is performed at 9600 baud. Only an external test requires a loopback cable.

To display the route that packets take to get to a network host:

diag traceroute <IP Address or Hostname>

To verify that the host is up and running:

diag ping <IP Address or Name> [<parameters>]

Parameters:

count <Number of Times to Ping>

The default is 5.

packetsize <Size in Bytes>

The default is 64.

To display performance statistics for an Ethernet port or a device port (averaged over the last 5 seconds):

diag perfstat [ethport <12>] [deviceport <Device Port # or Name>]

SLB™ Branch Office Manager User Guide 198