Lantronix 900-510 manual Enable Radius, Radius Server #1, Server #1 Port, Server #1 Secret

	11: User Authentication
Enable RADIUS	Displays selected if you enabled this method on the User
	Authentication page. If you want to set up this authentication
	method but not enable it immediately, clear the checkbox.
	Note: You can enable RADIUS here or on the first User
	Authentication page. If you enable RADIUS here, it
	automatically displays at the end of the order of precedence
	on the User Authentication page.
RADIUS Server #1	IP address or hostname of the primary RADIUS server. This
	RADIUS server may be a proxy for SecurID.
	SecurID is a two-factor authentication method based on the
	user's SecurID token and pin number. The SecurID token
	displays a string of digits called a token code that changes
	once a minute (some tokens are set to change codes every
	30 seconds).
Server #1 Port	Number of the TCP port on the RADIUS server used for the
	RADIUS service. If you do not specify an optional port, the
	SLB branch office manager uses the default RADIUS port
	(1812).
Server #1 Secret	Text that serves as a shared secret between a RADIUS client
	and the server (SLB device). The shared secret is used to
	encrypt a password sent between the client and the server.
	May have up to 128 characters.
RADIUS Server #2	IP address or host name of the secondary RADIUS server.
	This server can be used as a SecurID proxy.
Server #2 Port	Number of the TCP port on the RADIUS server used for the
	RADIUS service. If you do not specify an optional port, the
	SLB branch office manager uses the default RADIUS port
	(1812).
Server #2 Secret	Text that serves as a shared secret between a RADIUS client
	and the server (SLB device). The shared secret is used to
	encrypt a password sent between the client and the server.
	May have up to 128 characters.
Timeout	The number of seconds (1-30) after which the connection
	attempt times out. The default is 30 seconds.
Custom Menu	If custom menus have been created, you can assign a default
	custom menu to RADIUS users.
Escape Sequence	A single character or a two-character sequence that causes
	the SLB branch office manager to leave direct (interactive)
	mode. (To leave listen mode, press any key.)
	A suggested value is Esc+A (escape key, then uppercase
	"A" performed quickly but not simultaneously). You would
	specify this value as \x1bA, which is hexadecimal (\x)
	character 27 (1B) followed by an A.
	This setting allows the user to terminate the connect
	direct command on the command line interface when the
	endpoint of the command is deviceport, tcp, or udp.

SLB™ Branch Office Manager User Guide 155