Lantronix 900-510 manual Enable TACACS+, TACACS+ Servers, Secret

		11: User Authentication
2. Enter the following:
	Enable TACACS+	Displays selected if you enabled this method on the User
		Authentication page. If you want to set up this authentication
		method but not enable it immediately, clear the checkbox.
		You can enable TACACS+ here or on the first User Authentication
		page. If you enable TACACS+ here, it automatically displays at
		the end of the order of precedence on the User Authentication
		page.
	TACACS+ Servers	IP address or host name of up to three TACACS+ servers.
1-3
	Secret	Shared secret for message encryption between the SLB branch
		office manager and the TACACS+ server. Enter an alphanumeric
		secret of up to 127 characters.
	Encrypt Messages	Select the checkbox to encrypt messages between the SLB
		device and the TACACS+ server. Selected by default.
	Custom Menu	If custom menus have been created (see the User Guide), you
		can assign a default custom menu to TACACS+ users.
	Escape Sequence	A single character or a two-character sequence that causes the
		SLB branch office manager to leave direct (interactive) mode. (To
		leave listen mode, press any key.)
		A suggested value is Esc+A (escape key, then uppercase "A"
		performed quickly but not simultaneously). You would specify this
		value as \x1bA, which is hexadecimal (\x) character 27 (1B)
		followed by an A.
		This setting allows the user to terminate the connect direct
		command on the command line interface when the endpoint of the
		command is deviceport, tcp, or udp.
	Break	A series of 1-10 characters users can enter on the command line
	Sequence	interface to send a break signal to the external device. A
		suggested value is Esc+B (escape key, then uppercase “B”
		performed quickly but not simultaneously). You would specify this
		value as \x1bB, which is hexadecimal (\x) character 27 (1B)
		followed by a B.
	Data Ports	The ports users are able to monitor and interact with using the
		connect direct command. U and L denote the upper and
		lower slots of the PC Card.
	Listen Port	The ports users are able to monitor using the connect listen
		command.
	Clear Port Buffers	The ports whose port buffer users may clear using the set
		locallog clear command.
	Access Outlets	The power outlets users may monitor and configure.

3.In the User Rights section, select the user group to which TACACS+ users will belong.

SLB™ Branch Office Manager User Guide 164