6: Basic Parameters

Network Commands

The following CLI commands correspond to the web page entries described above.

To configure Ethernet port 1 or 2:

set network port <12> <parameters>

Parameters:

mode <auto10mbit-half100mbit-half 10mbit-full100mbit-full>

state <dhcpbootpstaticdisable> [ipaddr <IP Address> mask <Mask>]

[ipv6addr <IP v6 AddressPrefix>]

To configure up to three DNS servers:

set network dns <123> ipaddr <IP Address>

To set the default and alternate network gateways:

set network gateway <parameters>

Parameters:

default <IP Address> precedence <dhcpgprsdefault> alternate <IP Address> pingip <IP Address>

ethport <1 or 2> pingdelay <1-250 seconds> failedpings <1-25>

The alternate gateway is used if an IP address usually accessible through the default gateway fails to return one or more pings.

To set the SLB host name and domain name:

set network host <Hostname> [domain <Domain Name>]

To set TCP Keepalive and IP Forwarding network parameters:

set network <parameters>

Parameters:

interval <1-99999 Seconds> ipforwarding <enabledisable> probes <Number of Probes> startprobes <1-99999 Seconds>

SLB™ Branch Office Manager User Guide

52

Page 52
Image 52
Lantronix 900-510 manual Network Commands