Lantronix 900-510 Base, Bind Name, Bind Password, Retype Password, Active Directory, Support

	11: User Authentication
Base	The name of the LDAP search base (e.g., dc=company, dc=com).
	May have up to 80 characters.
Bind Name	The name for a non-anonymous bind to an LDAP server. This item
	has the same format as LDAP Base. One example is
	cn=administrator,cn=Users,dc=domain,dc=com
Bind Password and	Password for a non-anonymous bind. This entry is optional.
Retype Password	Acceptable characters are a-z, A-Z,and 0-9.
	The maximum length is 127 characters.
Active Directory	Select to enable. Active Directory is a directory service from
Support	Microsoft that is a part of Windows 2000 and later versions of
	Windows. It is LDAP- and Kerberos- compliant. Disabled by
	default.
Encrypt Messages	Select to encrypt messages between the SLB branch office
	manager and the LDAP server. Disabled by default.
Custom Menu	If custom menus have been created (see Custom User Menus on
	page 174), you can assign a default custom menu to LDAP users.
Escape Sequence	A single character or a two-character sequence that causes the
	SLB branch office manager to leave direct (interactive) mode. (To
	leave listen mode, press any key.)
	A suggested value is Esc+A (escape key, then uppercase "A"
	performed quickly but not simultaneously). You would specify this
	value as \x1bA, which is hexadecimal (\x) character 27 (1B)
	followed by an A.
	This setting allows the user to terminate the connect direct
	command on the command line interface when the endpoint of the
	command is deviceport, tcp, or udp.
Break	A series of 1-10 characters users can enter on the command line
Sequence	interface to send a break signal to the external device. A suggested
	value is Esc+B (escape key, then uppercase “B” performed quickly
	but not simultaneously). You would specify this value as \x1bB,
	which is hexadecimal (\x) character 27 (1B) followed by a B.
Data Ports	The ports users are able to monitor and interact with using the
	connect direct command. U and L denote the PC Card upper
	and lower slots.
Listen Port	The ports users are able to monitor using the connect listen
	command.
Clear Port Buffers	The ports whose port buffer users may clear using the set
	locallog clear command.
Access Outlets	The outlets the user may monitor and configure.

3. In the User Rights section, select the user group to which LDAP users will belong:

SLB™ Branch Office Manager User Guide 151