Lantronix 900-510 manual Ethernet Counters, Hostname & Name Servers

		6: Basic Parameters
Hostname & Name Servers
	Hostname	The default host name is slbXXXX, where XXXX is the last
		4 characters of the hardware address of Ethernet Port 1.
		There is a 64-character limit (contiguous characters, no
		spaces). The host name becomes the prompt in the
		command line interface.
	Domain	If desired, specify a domain name (for example,
		support.lantronix.com). The domain name is used for host
		name resolution within the SLB branch office manager. For
		example, if abcd is specified for the SMTP server, and
		mydomain.com is specified for the domain, if abcd cannot
		be resolved, the SLB device attempts to resolve
		abcd.mydomain.com for the SMTP server.

DNS Servers

DNS Servers #1 - #3

Configure up to three name servers. #1 is required if you choose to configure DNS (Domain Name Server) servers.

The first three DNS servers acquired via DHCP through Eth1 and/or Eth2 display automatically.

DHCP-Acquired DNS Servers

#1 - #3

Displays the IP address of the name servers if automatically assigned by DHCP.

GPRS-Acquired DNS Servers

#1 - #3

Displays the IP address of the name servers if automatically assigned by General Packet Radio Service (GPRS).

TCP Keepalive Parameters

Start Probes	Number of seconds the SLB branch office manager waits
	after the last transmission before sending the first probe to
	determine whether a TCP session is still alive. The default
	is 600 seconds (10 minutes).
Number of Probes	Number of probes the SLB device sends before closing a
	session. The default is 5.
Interval	The number of seconds the SLB branch office manager
	waits between probes. The default is 60 seconds.

3.To save your entries, click the Apply button. Apply makes the changes immediately and saves them so they will be there when the SLB branch office manager is rebooted.

Ethernet Counters

The Network-Settings page displays statistics for each of the SLB Ethernet ports since boot-up. The system automatically updates them.

Note: For Ethernet statistics for a smaller time period, use the diag perfstat command.

SLB™ Branch Office Manager User Guide 51