Table 3-3 Telnet Commands and Parameters (continued)
| Reset to TCP/IP factory default settings after a cold reset. (Parameters for other |
| subsystems, such as IPX/SPX or AppleTalk, are not affected.) |
| 0: Disable. Retain TCP/IP settings after a cold reset. |
| 1: Enable. Restore factory default TCP/IP settings. |
|
|
| ICMPv4 time stamp requests. |
| 0 (default): Disable |
| 1: Enable |
|
|
| Allow use of the HP Embedded Web Server on the HP Jetdirect print server. |
| 0 Disable. |
| 1 (default): Enable. |
| For more information, see HP Embedded Web Server (V.45.xx.nn.xx) on page 63. |
|
|
| Time interval for the HP Embedded Web Server diagnostic page updates. Set from 1 to |
| 99999 seconds. |
| 0: Disable. |
|
|
| Maximum segment size (MSS) that the HP Jetdirect print server advertises for use when |
| communicating with local subnets (Ethernet MSS=1460 bytes or more) or remote |
| subnets (MSS=536 bytes). |
| 0 (default): All networks are assumed to be local (Ethernet MSS=1460 bytes or more). |
| 1: Use MSS=1460 bytes (or more) for subnets, and MSS=536 bytes for remote |
| networks. |
| 2: All networks are assumed to be remote (MSS=536 bytes), except the local subnet. |
| MSS affects performance by preventing IP fragmentation that can result in data |
| retransmission. |
|
|
| Maximum segment life (MSL) in seconds. Set from 5 to 120 seconds. |
| 0: Disable. |
| 15 (default): Enable. |
|
|
| Automatically assign the device IP address as the gateway when a network gateway is |
| not configured. |
| 0: Assign a gateway using the device IP address. |
| 1: Do not assign a gateway. The gateway address 0.0.0.0 is configured. |
|
|
| IP address to use when the print server is unable to obtain an IP address from the |
| network during a forced TCP/IP |
| on, or manually configured to use BOOTP/DHCP. |
| DEFAULT_IP: Set the legacy default IP address 192.0.0.192. |
| AUTO_IP: Set a |
| The initial setting is determined by the IP address obtained when first turned on. |
|
|
ENWW | IPv4 configuration 53 |
