HP 640n Print Server manual 2TFTP configuration file parameters, General

Example HP Jetdirect TFTP configuration file

#Allow subnet 192.168.10.0 access allow: 192.168.10.055.255.255.0

#Disable Telnet

telnet-config: 0

#

#Enable the embedded Web server ews-config: 1

#Detect SNMP unauthorized usage auth-trap: on

#Send traps to 192.168.10.1

trap-dest: 192.168.10.1

#

#Specify the Set Community Name set-cmnty-name: 1homer2

#End of File

Set allow to enable subnet 192.168.10.0 with access to the printer. This specifies a host or network of hosts that can connect to the print server. Add up to 10 entries using TFTP, Telnet, or the

HP Embedded Web Server. You can also specify single IP addresses for specific systems. The following list describes the example TFTP configuration file settings:

telnet-configSet to zero (0). Cannot use Telnet. ews-configSet to one (1). Use the HP Embedded Web Server. auth-trapSet to on. Send SNMP authentication traps. trap-destIP address of the system to send SNMP traps to.

set-cmnt-nameCommunity name required in SNMP Set commands.

This table describes the TFTP command parameters supported by HP Jetdirect print servers. (Optional commands for the same function are shown in parentheses.)

Table 3-2TFTP configuration file parameters

General

passwd: (or passwd-admin:)

Administrator's password to control access to HP Jetdirect print server configuration parameters using Telnet, HP Web Jetadmin, or the HP Embedded Web Server. Enter up to 16 alphanumeric characters. Clear the password with a cold reset.

sys-location: (or host-location:,location:)

Physical location of the printer (SNMP sysLocation object). Enter up to 64 alphanumeric characters. The default location is undefined.

sys-contact: (or host-contact:,contact:)

Name of the network or device administrator (SNMP sysContact object) who administers or services the printer. Enter up to 64 alphanumeric characters. The default contact is undefined.

26 Chapter 3 TCP/IP configuration ENWW