HP 640n Print Server Summary tab, TCP/IP Settings, TCP/IP Settings, ●Summary tab on page, ●Advanced tab on page, ●TCP/IP(v4) tab on page, ●TCP/IP(v6) tab on page

The TCP/IP Settings menu provides access to the following tabs:

This tab provides a summary of the TCP/IP configuration. Items on this page are described in the following table.

Table 4-4TCP/IP Summary tab

Item	Description

Host Name	IP host name assigned to the device and stored on the HP Jetdirect print server.
	To configure a host name, see the Network Identification tab.

IPv4 Status	Status of the IPv4 protocol. You cannot disable IPv4 from the HP Embedded Web
	Server in this release.

Fully Qualified Domain Name	Consists of the device's host name and domain name. Unless the network
(IPv4/IPv6)	administrator segments domains into separate IPv4 and IPv6 hosts, you can use the
	FQDN on either IPv4 or IPv6 networks simultaneously.

IPv4 Address	IPv4 address, subnet mask and default gateway for the print server.

Config By	IPv4 parameters configured using: DHCP, BOOTP, Manual, or Auto IP.

DHCP Lease Time	Duration of the DHCP IP address lease (in seconds) for the print server. Populated if
	DHCP configuration is used.

IPv6 Status	Status of the IPv6 protocol. Enable or disable using the HP Embedded Web Server.

Fully Qualified Domain Name	Consists of the device's host name and domain name. Depending on the network
(IPv6 only)	architecture, it can be the same as, or different from, the printer's IPv4 FQDN. If
	assigned, it applies to the IPv6 network only.

74 Chapter 4 HP Embedded Web Server (V.45.xx.nn.xx)

ENWW