Table
Status | |
| READY: HP Jetdirect print server is awaiting data. |
| DISABLED: AppleTalk was manually disabled. |
| INITIALIZING: Print server is registering the node address or name. An additional |
| status message might also be displayed. |
|
|
DLC/LLC |
|
|
|
Use DLC/LLC protocol operation on the print server (if supported). | |
| 0: Disable. |
| 1 (default): Enable. |
| NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are |
| disabled by factory default. |
|
|
Controls DLC/LLC protocol interpretation: | |
| 0 (default): Disable. Provide loose interpretation. |
| 1: Enable. Provide strict interpretation. |
|
|
Other |
|
|
|
upgrade | Set the name and location of the firmware upgrade file for the HP Jetdirect print servers. |
| CAUTION: Ensure that command parameters are properly entered and that the |
| upgrade file is a higher version than the currently installed version. The print server |
| attempts to upgrade if the upgrade file contains a higher version than the installed |
| version. |
| The following is the command format: |
| upgrade: <TFTP server IP> <Version> <Product Number> <Filename> |
| The following defines the parameters: |
| <TFTP Server IP> IP address of the TFTP server, <Version> firmware version of |
| the upgrade file, <Product Number> print server product number <Filename> path |
| and filename of the firmware upgrade file. |
|
|
laa | Specify a locally administered address (LAA) to replace the |
| hardware (MAC) address. If LAA is used, enter a string of exactly 12 hexadecimal digits. |
| For Ethernet print servers, the LAA must start with hexadecimal X2, X6, XA, or XE, |
| where X is any hexadecimal digit 0 through F. |
| The default address is the |
|
|
Allow access by HP Web service applications to | |
| print server. |
| 0: Disable. |
| 1 (default): Enable. |
|
|
Allow Microsoft WS discovery protocols on the print server. | |
| 1 (default): Enable. |
| 0: Disable. |
|
|
ENWW | IPv4 configuration 57 |