HP 640n Print Server manual Ampdu Aggregation, Network-type, Desired-ssid, Auth-type, Server-auth

Table 3-3Telnet Commands and Parameters (continued)

AMPDU Aggregation	Aggregating 802.11n MAC protocol data units packs them into frames to reduce
	overhead and increase the data rate. Enabling aggregation allows a maximum frame
	size of 64k bytes.
	ENABLE (default):Enable aggregation.
	DISABLE: Disable aggregation.
network-type	802.11bgn wireless network topology:
	Infrastructure: The print server communicates on the network with other wired or
	wireless devices through an access point.
	Ad Hoc: (default) The print server communicates with other wireless devices directly,
	without using an access point.
desired-ssid	Service set identifier (SSID), or network name, for the print server. Enter up to 32
	alphanumeric characters.
	The factory-default SSID is hpsetup in ad hoc mode. Do not use the SSID hpsetup
	with the Infrastructure network type.
	If the ssid command is issued without an entry (a blank SSID), the desired SSID is
	assigned <AUTO>, where it associates with the first network that matches its
	authentication settings.
auth-type	Link-based authentication method for the print server (before network use is allowed).
	Open (default): Use open system authentication if your wireless network does not
	require authentication for network use. However, your network might use WEP
	encryption keys for data security.
	Shared_Key: Use shared key authentication if your network requires that each device
	be configured with the same secret WEP key for network use.
	Selecting Shared_Key is not valid with the wpa-auth-typecommand when setting
	WPA-PSK authentication.
server-auth	Use server-based authentication.
	EAP_TLS: Use EAP-TLS authentication.
	NONE (default): Do not use server-based authentication.
	PEAP: Use PEAP authentication.
svr-auth-user	802.1x server authentication user identity. Enter up to 128 characters.
svr-auth-pass	Server authentication password. Enter up to 128 characters.
svr-auth-id	Server authentication ID, using the form: [<server(host name string)] The default value is
	RIGHT_MOST.
wpa-auth-type	WPA-PSK authentication and dynamic wi-fi protected access (WPA) encryption. WPA-
	PSK provides enhanced authentication on networks where an authentication server is
	not used. (Not compatible with the shared key authentication option in the auth-type
	command.)
	NONE: WPA-PSK authentication is not used.
	PSK: Selects WPA-PSK authentication. A pre-shared key provides device authentication
	and is generated when you specify a network passphrase through the psk-
	passphrase command.

44 Chapter 3 TCP/IP configuration ENWW