2-21

Simplex Enabler Board

The Simplex Enabler board is removed when changing the Wide-Ultra drive cage assembly to Duplex mode.

To remove the Simplex Enabler board:

1.Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2.Remove the drive cage assembly. See “Drive Cage Assemblies” earlier in this chapter.

3.Pull the Simplex Enabler board off the plugs on the back of the drive cage assembly.

Figure 2-17. Removing the Simplex Enabler Board

Reverse steps 1 through 3 to replace the Simplex Enabler board.

Duplex Enabler Board

The Duplex Enabler board ships in the country specific kit with every Wide-Ultra drive cage assembly. It is removed and replaced using the same steps as the Simplex Enabler board. The Duplex Enabler board has a SCSI connector for removable media use. Before removing the Duplex Enabler board, be sure to disconnect any SCSI cables.

Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide

Page 34
Image 34
Compaq 113803-001 manual Simplex Enabler Board, Duplex Enabler Board