Compaq 113803-001 Slot x Drive, SMART-2 Controller error, Progress, Array Drives, Port Address

			3-11
POST Error Messages Continued
	Audible Beeps
Error Code	L=Long S=Short	Probable Source of Problem		Recommended Action
1768-Slot x Drive	None	SMART-2 Controller error		No action required. Appears whenever
Array -Resuming				a controller reset or power cycle
logical drive				occurs while array expansion is in
expansion process.				progress.
1769-Slot x Drive	None	SMART-2 Controller error.		Data has been lost while expanding the
Array - Drive(s)				array, therefore the drives have been
disabled due to failure				temporarily disabled. Press F2 to
during expand. Select				accept the data loss and re-enable the
F1 to continue with				logical drives. Restore data from
logical drives				backup.
disabled. Select F2 to
accept data loss and
to re-enable logical
drives.

1771-Primary Disk	None	Internal and external hard drive
Port Address		controllers are both assigned
Assignment Conflict		to the primary address.
1772-Secondary Disk	None	Address Assignment Conflict.
Port Address		Internal and external hard drive
Assignment Conflict		controllers are both assigned
		to the secondary address.
1773-Primary Fixed	None	Fixed disk drive error.
Disk Port Assignment
Conflict
1774-Slot x Drive	None	SMART-2 Controller error.
Array - Obsolete data
found in Array
Accelerator. Select F1
to discard contents of
Array Accelerator.
Select F2 to write
contents of Array
Accelerator to drives.

Run the System Configuration Utility and correct.

Run the System Configuration Utility and correct.

Run the System Configuration Utility and correct.

Data found in Array Accelerator is older than data found on drives. Press F1 to discard the older data in the Array Accelerator and retain the newer data on the drives.

1776-Drive Array -	None	External and internal SCSI
SCSI Port Termination		drives are both configured to
Error		Port 1.
1777-Drive Array	None	Cooling fan failure, internal
External Drive		temperature alert or open side
Subsystem Error		panel.

Reconfigure drives.

Inspect for cooling fan failure or open side panel.

Continued

Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide