
POST Error Messages Continued
|
| Audible Beeps |
|
|
Error Code |
| L=Long S=Short |
| Probable Source of Problem |
| None |
| This message appears | |
resuming Automatic |
|
|
| whenever a controller reset or |
Data Recovery |
|
|
| power cycle occurs while |
process |
|
|
| Automatic Data Recovery is in |
|
|
|
| progress. |
|
|
|
|
|
| None |
| Intermittent drive failure and/or | |
Controller detects |
|
|
| possible loss of data. |
replacement drives |
|
|
|
|
Recommended Action
No action necessary.
If this message appears and drive X has not been replaced, this indicates an intermittent drive failure. This message also appears once immediately following drive replacement whenever data must be restored from backup.
None | Hard drive/format error. | |
|
|
|
None | Hard drive/format error. | |
|
|
|
None | Hard disk drive circuitry error. | |
Failure |
|
|
|
|
|
| None | Defective drive and/or cables. |
Drive Failure, Physical |
|
|
Drive |
|
|
|
|
|
None | Configuration error. | |
Configured |
|
|
|
|
|
| None | Interim Data Recovery mode. |
Recovery Needed |
| Data has not been recovered |
The following drive(s) |
| yet. |
|
| |
need Automatic Data |
|
|
Recovery: Drive X. |
|
|
Select "F1" to |
|
|
continue with |
|
|
recovery of data to |
|
|
drive(s). |
|
|
Select "F2" to |
|
|
continue without |
|
|
recovery of data to |
|
|
drive(s). |
|
|
Run Diagnostics. Replace failed assembly as indicated.
Run Diagnostics. Replace failed assembly as indicated.
Run Diagnostics. Replace failed assembly as indicated.
Check for loose cables. Replace defective drive X and/or cable(s).
Run the System Configuration Utility and correct.
Press F1 key to allow Automatic Data Recovery to begin. Data will automatically be restored to drive X now that the drive has been replaced or now seems to be working.
Press the F2 key and the system will continue to operate in the Interim Data Recovery mode.
Continued