Compaq 113803-001 manual Channel Access Panel, Removing the U-channel access panel

2-11

U-Channel Access Panel

The U-channel access panel is removed for replacement only. To remove the U-channel access panel:

1.Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2.Pull the drive cage assembly forward until it clears the front edge of the U-channel access panel. See “Drive Cage Assembly” later in this chapter.

3.Remove the caster mounting support. See “Caster Mounting Support” earlier in this chapter.

4.Remove the two T-15 screws securing the U-channel access panel to the chassis.

5.Slide the U-channel access panel forward, then pull it away from the chassis.

Figure 2-7. Removing the U-channel access panel

Reverse steps 1 through 5 to replace the U-channel access panel.

Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide