Compaq 113803-001 manual Power Supply Blank Panel, Removing the power supply cover plate

2-39

Power Supply Blank Panel

The power supply blank panel is removed to install a redundant power supply.

To remove the power supply blank panel:

1.Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2.Remove the two T-15 screws securing the power supply cover plate to the chassis.

3.Pull the power supply cover plate away from the chassis.

Figure 2-35. Removing the power supply cover plate

Reverse steps 1 through 3 to replace a power supply cover plate.

CAUTION: The power supply cover plate or the optional hot-plug redundant power supply must be present in bay 2 to maintain proper cooling of drive bays.

Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide