Symbols in Equipment
WARNING: Any surface or area of the equipment marked with these symbols indicates the presence of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce risk of injury from a hot component, allow the surface to cool before touching.
WARNING: Any surface or area of the equipment marked with these symbols indicates the presence of electrical shock hazards. The enclosed area contains no operator serviceable parts. To reduce risk of injury from electrical shock hazards, do not open this enclosure.
WARNING: Any
WARNING: This label or equivalent is located on the surface of your
CLASS 1 LASER PRODUCTCD-ROM drive. This label indicates that the product is classified as a
CLASS 1 LASER PRODUCT.
Preparation Procedures
Before beginning any
1.Turn OFF the server and any peripheral devices.
2.Disconnect the AC power cord from the AC outlet, then from the server.
3.Disconnect all external peripheral devices from the server.
4.For most removal and replacement procedures, you must remove the server from the rack and place it on a sturdy table or workbench. Refer to the ProLiant 3000 Server Setup and Installation Guide for rack removal instructions.
WARNING: To reduce the risk of personal injury, do not attempt to remove the server from the rack by yourself. A minimum of two people are required to remove the server from the rack.
WARNING: Because the rack allows you to stack computer components on a vertical rather than horizontal plane, you must take precautions to provide for rack stability and safety. It is important that you follow these precautions to provide for rack stability and safety, and to protect both personnel and property. Heed all cautions and warnings throughout the installation instructions that came with the server.
CAUTION: Electrostatic discharge can damage electronic components. Be sure you are properly grounded before beginning any installation procedure. See the section titled “Electrostatic Discharge” for more information.
