
2-44 Removal and Replacement Procedures
3.Connect the battery cable to battery header E9 on the system board.
4.Remove the adhesive backing from the
Figure 2-39. Installing the external replacement battery
5.Change toggle 1 on switchbank SW2 to the OFF position on the system board.
See Chapter 4, “Connectors, Switches, Jumpers, and LEDs” for more information on the external replacement battery.
6.Place the label included with your battery kit on the back of your server above the power connector.
7.Run the Compaq System Configuration Utility to reconfigure the system. See Chapter 3, “Diagnostic Tools,” for more information.
NOTE: If the replacement battery fails or is defective, properly dispose of the failed battery and repeat steps 3 through 7.