Compaq 113803-001 manual Front Fixed Bezel, Removing the front fixed bezel

2-8Removal and Replacement Procedures

Front Fixed Bezel

The front fixed bezel must be removed to replace the power switch. To remove the front fixed bezel (tower model only):

1.Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2.Open the front bezel door.

3.Remove the seven T-15 screws securing the front fixed bezel to the chassis.

4.Pull the front fixed bezel away from the chassis.

Figure 2-4. Removing the front fixed bezel

NOTE: Drive cage may not be as illustrated.

Reverse steps 1 through 4 to replace the front fixed bezel.