POST Error Messages Continued

 

 

Audible Beeps

 

 

Error Code

 

L=Long S=Short

 

Probable Source of Problem

1793-Drive Array -

 

None

 

This indicates that while the

Array Accelerator

 

 

 

system was in use, power was

Battery Depleted -

 

 

 

interrupted while data was in

Data Lost

 

 

 

the Array Accelerator memory.

(Error message 1794

 

 

 

Array Accelerator batteries

 

 

 

failed. Data in Array

also displays.)

 

 

 

 

 

 

Accelerator has been lost.

 

 

 

 

 

 

 

 

 

1794-Drive Array -

 

None

 

This is a warning that the

Array Accelerator

 

 

 

battery charge is below 75%.

Battery Charge Low.

 

 

 

Posted-writes are disabled.

Array Accelerator is

 

 

 

 

temporarily disabled.

 

 

 

 

Array Accelerator will

 

 

 

 

be re-enabled when

 

 

 

 

battery reaches full

 

 

 

 

charge.

 

 

 

 

 

 

 

 

 

3-15

Recommended Action

Power was not restored within eight to ten days. Perform orderly system shutdowns to avoid data remaining in the Array Accelerator.

Replace the Array Accelerator board if batteries do not recharge within 36 power-on hours.

1795-Drive Array -

None

This indicates that while the

Array Accelerator

 

system was in use, power was

Configuration Error.

 

interrupted while data was in

Data does not

 

the Array Accelerator memory.

 

 

correspond to this

 

The data stored in the Array

drive array. Array

 

Accelerator does not

Accelerator is

 

correspond to this drive array.

temporarily disabled.

 

 

 

 

 

1796-Drive Array -

None

Array Accelerator is defective

Array Accelerator Not

 

or has been removed.

Responding.

 

 

Array Accelerator is

 

 

temporarily disabled.

 

 

 

 

 

1797-Drive Array -

None

Hard parity error while reading

Array Accelerator

 

data from posted-writes

Read Error Occurred.

 

memory.

Data in Array

 

 

Accelerator has been

 

 

lost. Array Accelerator

 

 

is disabled.

 

 

 

 

 

Match the Array Accelerator to the correct drive array, or run the System Configuration Utility to clear the data in the Array Accelerator.

1.Check that the Array Accelerator is properly seated.

2.Run the System Configuration Utility to reconfigure the Compaq IDA-2 without the Array Accelerator.

Enable Array Accelerator.

Continued

Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide

Page 72
Image 72
Compaq 113803-001 Battery Depleted, Data Lost, Array Accelerator batteries, Failed. Data in Array, Drive Array None