Compaq 113803-001 manual Scsi cable, Incorrect cabling, Driver Required Services System halted

POST Error Messages Continued

	Audible Beeps
Error Code	L=Long S=Short	Probable Source of Problem
1702-SCSI cable	None	Incorrect cabling.
error detected.
System halted.

1703-SCSI cable	None	Incorrect cabling.
error detected.
Internal SCSI cable
not attached to
system board
connector. System
halted.
1704-Unsupported	None	System attempted to perform a
Virtual Mode Disk		virtual mode disk operation
Operation. DOS		without virtual mode memory
Driver Required.		services.
System halted.
1705-Locked SCSI	None	SCSI bus failure.
Bus Detected.
System halted.
1730-Fixed Disk 0	None	Fixed disk drive error.
does not support
DMA Mode.
1731-Fixed Disk 1	None	Fixed disk drive error.
does not support
DMA Mode.
1740-Fixed Disk 0	None	Fixed disk drive error.
failed Set Block
Mode command
1741-Fixed Disk 1	None	Fixed disk drive error.
failed Set Block
Mode command
1750-Fixed Disk 0	None	Fixed disk drive error.
failed Identify
command

3-9

Recommended Action

1.For integrated SCSI Controllers, ensure that the internal connector has SCSI termination attached.

2.For option card SCSI controllers, ensure that only one of the two internal connectors has termination attached.

Ensure that the integrated SCSI controller has SCSI termination attached.

Use fixed-disk device driver that supports virtual mode memory services.

Run Diagnostics. Replace failed assembly as indicated.

Run the System Configuration Utility and correct.

Run the System Configuration Utility and correct.

Run the System Configuration Utility and correct.

Run the System Configuration Utility and correct.

Run the System Configuration Utility and correct.

Continued

Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide