3-10Diagnostic Tools

POST Error Messages Continued

 

 

Audible Beeps

 

 

Error Code

 

L=Long S=Short

 

Probable Source of Problem

1751-Fixed Disk 1

 

None

 

Fixed disk drive error.

failed Identify

 

 

 

 

command

 

 

 

 

 

 

 

 

 

1760-Fixed Disk 0

 

None

 

Fixed disk drive error.

does not support

 

 

 

 

Block Mode

 

 

 

 

 

 

 

 

 

1761-Fixed Disk 1

 

None

 

Fixed disk drive error.

does not support

 

 

 

 

Block Mode

 

 

 

 

 

 

 

 

 

1764-Slot x Drive Array - Capacity Expansion Process is temporarily disabled (followed by one of the following):

νExpansion will resume when Array Accelerator has been reattached.

νExpansion will resume when Array Accelerator has been replaced.

νExpansion will resume when Array Accelerator RAM allocation is successful.

νExpansion will resume when Array Accelerator battery reaches full charge.

νExpansion will resume when automatic data recovery has been completed.

1765-Slot x Drive Array Option ROM Appears to Conflict With an ISA Card. ISA cards with 16-bit memory cannot be configured in memory range C0000 to DFFFF along with the SMART-2/E 8-bit Option ROM due to EISA bus limitations. Please remove or reconfigure your ISA card.

1766-Slot x Drive Array requires System ROM Upgrade. Run Systems ROMPaq Utility.

1767-Slot x Drive Array Option ROM is Not Programmed Correctly or may Conflict with the Memory Address Range of an ISA Card. Check the Memory Address Configuration of installed ISA Card(s) or run Options ROMPaq Utility to attempt SMART-2/E Option ROM Reprogramming.

Recommended Action

Run the System Configuration Utility and correct.

Run the System Configuration Utility and correct.

Run the System Configuration Utility and correct.

Reattach or replace Array Accelerator, wait until the Array Accelerator batteries have charged, or for Automatic Data Recovery to complete, as indicated.

Remove or reconfigure conflicting ISA cards. Disable “shared memory” on any ISA network cards that may be installed.

Run the latest Systems ROMPaq Utility to upgrade your System ROMs.

Remove or reconfigure conflicting ISA cards, especially any cards that are not recognized by the System Configuration Utility. Try reprogramming the SMART-2/E Controller’s ROMs using the latest Options ROMPaq (version 2.29 or higher).

Continued

Page 67
Image 67
Compaq 113803-001 manual Failed Identify Command Fixed Disk, Does not support Block Mode Fixed Disk