Compaq 113803-001 manual Rack-Mount Bezel, Removing the rack-mount bezel

2-9

Rack-Mount Bezel

The rack-mount bezel (rack model only) must be removed to replace the power switch. To remove the rack-mount bezel:

1.Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2.Remove the seven T-15 screws securing the rack-mount bezel to the chassis.

3.Pull the rack-mount bezel away from the chassis.

Figure 2-5. Removing the rack-mount bezel

NOTE: Drive cage may not be as illustrated.

Reverse steps 1 through 3 to replace the rack-mount bezel.

Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide