Error Code Message Information
Action If unintended, re-enable logging.
SEL0006 Message All event logging is disabled.
Details This message is displayed when all event logging has been disabled
by the user.
Action If unintended, re-enable logging.
SEL0008 Message Log is full.
Details When the event log is full, additional events are not written to the log.
Older events may be overwritten and lost. This message may also
appear if the user disabled event logging.
Action Backup and clear log.
SEL0010 Message Log is almost full.
Details When the event log is full, additional events are not written to the log.
Older events may be overwritten and lost.
Action Backup and clear log at the next maintained time.
SEL0012 Message Could not create or initialize the system event log.
Details If the system event log fails to initialize, platform status and failure
events are not captured. Some management software do not report
platform exceptions.
Action Reboot the management controller or iDRAC. Cycle system input
power. If problem persists call support.
SEL1204 Message An unknown system hardware failure detected.
LCD Message Unknown system hardware failure.
Details If the system event log failed to initialize platform status and failure
events are not captured. Some management software will not report
platform exceptions.
Action Re-configure system to minimum supported configuration. If issues
persists, contact support.
SEL1209 Message The platform event filter action failed.
Details System policies or permissions may prevent the action from
executing. If configured, the system does not execute the action on
119