REAR PANEL: (Continued)
This switch simply allows you to switch between the two channels (CHANNEL 1 and CHANNEL 2) without using the Channel Select Footswitch or, when one is not available.
To use the footswitch however, the Channel Select switch must be in the (up) position.
CHANNEL 1
CHANNEL 2
SET TO CHANNEL 1
TO USE FOOTSWITCH
FUSE: | This is the A.C.’s (Alternating Current) main fuse and provides protection from outside A .C. fl uctuations as well as power |
|
tube failure damage. Should the FUSE blow, replace it with the same rating in a
PATENTED 4,211,000 & OTHERS PENDING FOR SOLO, MUTE & LOOP CONFIGURATION | STANDBY switch to the ON position. | |||
U | POWER FUSE | WARNING: | If a power tube is going bad or is arcing you will see it! Flip the STANDBY switch to Standby | |
| ||||
F E | 120 V~ | 2.5 A | immediately and replace the faulty power tube and the fuse if necessary. If you see nothing | |
F | before replacing | |||
|
|
| Unplug power |
|
E U | SLO | fuse or removing | abnormal as you lift the STANDBY switch it is possible that a power tube shorted temporarily | |
| 2.5 A | BLO | bolts mounting | |
| chassis. |
FUSE |
| and blew the FUSE . If this is the case it may work again normally.To be extra safe, you might |
|
| |
|
| want to replace just the adjacent tube or all power tubes in the “shotgun” troubleshooting |
|
| tradition and save the replaced set as spares. Spare fuses are a must for the fabled cord |
| HEAD VERSION | bag along with your spare tubes. Always carry both for they could be worth their weight in |
| gold someday. | |
|
|
A.C. RECEPTACLE: The total power consumption for the
necessary from time to time for noise problems.
POWER | FUSE | WARNING: | |
Unplug power | |||
120 V~ | 2.5 A | ||
before replacing | |||
SLO | fuse or removing | ||
bolts mounting | |||
2.5 A | BLO | chassis. |
This style of power cord will make
HEAD VERSION
PAGE 11