Chapter 3: Software Installation

Actions:

Select Outbound Phone Book o Select Add Entry

o Accept Any Number may be selected to allow unmatched destinations an alternative

o Enter the number necessary to get out from the PBX system followed by the calling code of the destination in the Destination Pattern field

o Enter the PBX access digit (same number as needed to get out of the PBX system) in the Remove Prefix field

o Any digits that need to be added should be put in the Add Prefix field

o Enter the IP address of the call destination (add a Description if you like)

o Select a Protocol type (–SS models use SIP only, -FX models do not support H.323)

ƒFor H.323:

Enter Gateway settings

ƒFor SIP:

Select Transport Protocol, Proxy and URL if needed

ƒFor SPP:

Enter Registrar settings if needed

oThe Advanced Button will allow an Alternate IP Address to be entered for outbound traffic

Select Inbound Phone Book

oSelect Add Entry

oAccept Any Number for inbound traffic does not work when external routing devices are used o Enter any access digits followed by the local calling code in the Remove Prefix field

o Enter any digits needed to access an outside line in the Add Prefix field

o Select Hunting in the Channel Number field to have the VOIP use the next available channel o Add a description if you like

o Call Forward may be set up (details available in Chapter 5) o Select Registration Option

Repeat the Phone Book steps for any additional entries needed

Save & Reboot

Any time that you change settings on the VOIP unit, you must choose the Save & Reboot option; otherwise all changes made will be lost when the MultiVOIP is reset or shutdown.

Multi-Tech Systems, Inc.

29

Page 29
Image 29
Multi-Tech Systems MVP210/410/810-FX, MVP210/410/810-SS manual Save & Reboot