Chapter 3: Software Installation

7.On the next screen you can select the COM port that the command PC will use when communicating with the MultiVOIP unit. After software installation, the COM port can be re-set in the MultiVOIP Software (from the sidebar menu, select Connection Settings to access the COM Port Setup screen or use keyboard shortcut Ctrl + G).

Note: If the COM port setting made here conflicts with the actual COM port resources available in the command PC, the “Error in Opencomm handle” message will appear when the MultiVOIP program is launched. If this occurs, you must reset the COM port.

8.A completion screen will appear.

Figure 3-4: Completion

Click Finish.

9.When setup of the MultiVOIP software is complete, you will be prompted to run the MultiVOIP software to configure the VOIP.

Figure 3-5: Configuration

Software installation is now complete.

Multi-Tech Systems, Inc.

18

Page 18
Image 18
Multi-Tech Systems MVP210/410/810-SS, MVP210/410/810-FX manual Completion