Multi-Tech Systems MVP210/410/810-FX, MVP210/410/810-SS manual Interface Parameters

Chapter 3: Software Installation

Interface

The Interface Parameters are the telephony settings that are to be applied to the individual MultiVOIP channels. Configure each channel for the type of interface you are using. Channel 1 is selected by default.

Note: Feature options are enabled or unavailable depending on the selected interface type. The one option available for all interface types is the inter digit timer option. This option defines the maximum amount of time that the unit will wait before mapping the dialed digits to an entry in the phone book database. If too much time elapses between digits, and the wrong numbers are mapped, you will hear rapid busy signal. If this happens, hang up and dial again.

If the Interface Type is FXS (Loop Start), a station device such as an analog telephone, fax machine or KTS (Key Telephone System) is connected to an analog channel. The FXS options group is active.

If the Interface Type is FXO, the Dialing Options Regeneration, Flash Hook Timer and Ring Count groups are enabled. The FXO Ring Count allows you to set the number of rings before the unit answers the incoming call. Check with your local in-house phone personnel to verify whether your local PBX dial signaling is pulse or tone (DTMF). The Flash Hook Options Generation setting allows you to enter the time, in milliseconds, for the duration of the flash hook signal.

If the Interface Type is E & M, you are connecting to an analog E & M trunk on your PBX. Check with your in- house phone personnel to determine the signaling type (Dial Tone or Wink) and if it is 2-wire or 4-wire. The –SS and –FX series do not support E&M or DID operation.

Figure 3-9: Interface Parameters

Multi-Tech Systems, Inc. 23