Chapter 4: Configuring your VOIP
FXS Loop Start Parameters
The parameters applicable to FXS Loop Start are shown in the figure below and described in the table that follows.
Figure 4-4: FXS Loop Start parameters
| FXS Loop Start Interface: Parameter Definitions | |
Field Name | Values | Description |
Dialing Options fields |
| |
FXS (Loop Start) | Y/N | Enables FXS Loop Start interface type. |
Inter Digit Timer | 1 - 10 seconds | This is the length of time that the MultiVOIP will wait between digits. |
|
| When the time expires, the MultiVOIP will look in the outbound |
|
| phonebook for the number entered and place the call accordingly. |
|
| Default = 2. |
Message Waiting | Not applicable to | |
Indication |
|
|
Inter Digit | in milliseconds | The length of time between the outputting of DTMF digits. |
Regeneration Time |
| Default = 100 ms. |
|
|
|
FXS Options fields |
| |
FXS Ring Count, | Maximum number of rings that the MultiVOIP will issue before giving | |
FXS |
| up the attempted call. |
Current Loss | Y/N | When enabled, the MultiVOIP will interrupt loop current in the FXS |
|
| circuit to initiate a disconnection. This tells the device connected to the |
|
| FXS port to hang up. The |
|
| device must go on hook. |
Generate Current | Y/N | When selected, this option implements Answer Supervision and |
Reversal |
| Disconnect Supervision to the FXO interface using current reversal to |
|
| indicate events. Applicable only when FXS and FXO interfaces are |
|
| connected back to back. |
Table is continued on next | page… |
|
41 |
