![](/images/new-backgrounds/1184070/18407099x1.webp)
50 Initial steps using the CLI
Table 7
Job aid: PPP file options
Option | Description |
|
|
asyncmap <value> | Configures the desired async map to |
| the value you specify. |
|
|
chap_file <file> | Obtains |
| Authentication Protocol (CHAP) |
| secrets from the specified file. You |
| require this option if either peer |
| requires CHAP authentication. If your |
| users must use the same IP address, |
| the PAP and CHAP secret files must |
| specify the same IP address for all |
| users and it must match the |
| setting on the modem port. |
|
|
chap_interval <value> | Configures the interval, in seconds, for |
| the CHAP rechallenge to the value you |
| specify. |
|
|
chap_restart <value> | Configures the timeout, in seconds, |
| for CHAP negotiation to the value you |
| specify. |
|
|
debug | Activates the PPP daemon debug |
| mode. |
|
|
default_route | Adds a default route to the system |
| routing table, after successful Internet |
| Protocol Control Protocol (IPCP) |
| negotiation. Use the peer as the |
| gateway. After the PPP connection |
| ends, the system removes this entry. |
|
|
driver_debug | Activates PPP driver debug mode. |
|
|
escape_chars <value> | Configures the characters to escape |
| on transmission to the value you |
| specify. |
|
|
ipcp_accept_local | Accepts what the remote peer uses as |
| the target local IP address, even if the |
| local IP address is specified. |
|
|
ipcp_accept_remote | Accepts what the remote peer uses as |
| the IP address, even if you specify the |
| remote IP address. |
|
|
ipcp_max_configure <value> | Configures the maximum number of |
| transmissions for IPCP configuration |
| requests to the value you specify. |
|
|
Nortel Ethernet Routing Switch 8600
Commissioning
30 May 2008