Lexmark X940E, X945E manual 139, Timeouts

Menu item	Description
Timeouts	Specifies the number of minutes of inactivity before the system
Standby Mode	enters a lower power state
Disabled	Note: 15 minutes is the factory default setting.
2–240
Timeouts	Specifies the number of minutes of inactivity before some
Power Saver Mode	systems begin entering a minimum power state.
Disabled	Notes:
2–240	•	60 minutes is the factory default setting.
	•	Power Saver does not interact with Standby Mode.
	•	Changing Power Saver should not cause Standby Mode
		to be changed.
Timeouts	Sets the amount of time in seconds the printer waits before
Screen Timeout	returning the printer display to a Ready state
15–300	Note: 30 seconds is the factory default setting.
Timeouts	Sets the amount of time in seconds the printer waits to receive
Print Timeout	an end-of-job message before canceling the remainder of the
	print job
Disabled
1–255	Notes:
	•	90 seconds is the factory default setting.
	•	When the timer expires, any partially printed page still in
		the printer is printed, and then the printer checks to see if
		any new print jobs are waiting.
	•	Print Timeout is available only when using PCL or PPDS
		emulation. This setting has no effect on PostScript
		emulation print jobs.
Timeouts	Sets the amount of time in seconds the printer waits for
Wait Timeout	additional data before canceling a print job
Disabled	Notes:
15–65535	•	40 seconds is the factory default setting.
	•	Wait Timeout is available only when the printer is using
		PostScript emulation. This setting has no effect on PCL or
		PPDS emulation print jobs.
Timeouts	Sets the amount of time in seconds that a network print job can
Network Job Timeout	take before it is canceled
1–255	Notes:
	•	90 seconds is the factory default setting.
	•	A setting value of 0 disables the timeout.
	•	If a value of 1–9 is selected, the setting will be saved as
		10.

139