N_One Wireless Broadband Router
If you can't connect
If the Wireless Broadband Router does not respond, check the following:
•The Wireless Broadband Router is properly installed, LAN connection is OK, and it is powered ON. You can test the connection by using the "Ping" command:
•Open the
•Enter the command:
ping 192.168.0.1
If no response is received, either the connection is not working, or your PC's IP address is not compatible with the Wireless Broad- band Router's IP Address. (See next item.)
•If your PC is using a fixed IP Address, its IP Address must be within the range 192.168.0.2 to 192.168.0.254 to be compatible with the Wireless Broadband Router's default IP Address of 192.168.0.1. Also, the Net- work Mask must be set to 255.255.255.0. See Chapter 4 - PC Configuration for details on checking your PC's TCP/IP settings.
•Ensure that your PC and the Wireless Broadband Router are on the same network segment. (If you don't have a router, this must be the case.)
•Ensure you are using the wired LAN interface. The Wireless interface can only be used if its configuration matches your PC's wireless set- tings.
Setup Wizard
The first time you connect to the Wireless Router, the Setup Wizard must be run.
1.Step through the Wizard until finished.
•You need to know the type of Internet connection service used by your ISP. Check the data supplied by your ISP.
•The common connection types are explained in the tables below.
2.On the final screen of the Wizard, run the test and check that an Internet connec- tion can be established.
3.If the connection test fails:
•Check your data, the Cable/DSL modem, and all connections.
•Check that you have entered all data correctly.
•If using a Cable modem, your ISP may have recorded the MAC (physical) ad- dress of your PC. Run the Wizard, and on the Cable Modem screen, use the "Clone MAC address" button to copy the MAC address from your PC to the Wireless Router.
13
