CONFIGURATION MODE — MANUAL CONTROL (Standard or Deluxe)
WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY FROM THE OVEN AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.
Identify the manufacturer(s) of the convection fan motor(s) by inspecting the label on the motor(s) after the rear panel is removed. This information is needed for Steps 8 – 10. Replace rear panel and reconnect electrical power.
Some of the procedures in this section are set at the factory and do not need to be
PressingTIME
repeatedly advances through each step 1 through 12 and then repeats from step 2.
After any keystroke where an individual setting is
either changed or accepted, the setting will display for three seconds and then automatically advances to the next step.
1. Configuration Mode can be entered only when the oven is OFF. With
the oven OFF, press and at the same time for about three seconds. [ Conf ] will be displayed in the temperature display to
indicate Configuration Mode. Press TIME to begin.
2.[ C F ] will be displayed in the TIME display to allow selection of the temperature scale. Turn the adjustment knob clockwise for Fahrenheit; turning counterclockwise would select Celsius. A blinking F indicates Fahrenheit is selected while a blinking C would indicate Celsius. After making a selection, the selection displays for three seconds and
automatically advances to the next step. Or, press TIME to advance to the next step.
3.[ dSCL ] is displayed in the TIME display and the number of clean cycles completed is displayed in the TEMPERATURE display. This
number cannot be changed or modified. Press TIME to advance to the next step.
4.The revision level of the control's software is displayed in the time
display and cannot be changed. This information is needed by your
service technician. Press TIME to advance to the next step.
5.[ HHHH ] is displayed in the TIME display and the total cooking hours of the oven is displayed in the temperature display. This can be reset.
Rotate the knob counterclockwise to decrease the number of hours; rotate the knob clockwise to increase the number of hours . Press TIME to advance to the next step.
6.[ bbbb ] is displayed in the TIME display and the buzzer is sounding to indicate the buzzer's
rotate the knob clockwise to increase buzzer frequency. Buzzer
loudness can be adjusted by your service technician. Press TIME to advance to the next step.
– 38 –