Vulcan-Hart manual Cooking Mode, COOKING TIME or PROBE TEMPERATURE, OVEN TEMPERATURE or, Down

ON	— After an initial power-up sequence, the control panel indicator lights and the light
	inside the oven are lit. The actual oven temperature is shown in the Temperature
	display, – h – – min is in the Time display, and – – is in the Program Number display.
	The control will now accept commands. The ON button also cancels a manual
	cooking operation of up to 5 Phases. • Open the water supply valve. See page 7.
OFF	— Shuts off the oven and oven light, opens the oven vent, and drains the steam
	generator tank (pump takes about a minute). • Close the water supply valve.

COOKING MODE

HOT AIR — Heat and Fan are ON; steam generator tank fills. Initial temperature setting is 302°F

(range is 35 – 518°F). Push once for Vent Closed,; twice for Vent Open, .

STEAM — Steam and Fan are ON; steam generator tank fills, if not already full. Initial temperature setting is 212°F (range is 35 – 212°F).

COMBI — Heat, Fan, and Steam are ON; steam generator tank fills, if not already full. Initial temperature setting is 302°F (range is 35 – 518°F). The amount of steaming is set by the number of times you press the Combi key (1 – 6), indicated by the row of lights.

START STOP— Starts or stops a cooking operation. Temperature flashes if door is not locked.

PHASE 1–5 — Indicates the Phase of a cooking program. Allows you to step through and display the cooking information for each phase of a cooking operation before starting.

COOKING TIME or PROBE TEMPERATURE

TIME — Displays the Cooking Time. Time remaining for ALL phases is normally displayed. Press the Time key again to display the time remaining for the current phase. When

- -- displays in the time display, the oven is in manual mode (no switch off at end).

DOWN — Decreases the Cooking Time or Probe Temperature setting.

UP — Increases the Cooking Time or Probe Temperature setting.

PROBE — Displays the Probe Temperature setting, initially 140°F, (range 70 – 210°F). After 5 seconds, displays the actual Probe Temperature.

OVEN TEMPERATURE or

TEMP — Displays the Oven Temp instead of . Normally displays the actual Oven Temp. Press Temp to display the Oven Temperature setting for 5 seconds and adjust it.

DOWN	— Decreases the Oven Temperature or					setting.
UP	—	Increases the Oven Temperature or				setting.
	— Displays		instead of Oven Temperature (temperature difference is indicated by
		__t in the display).			keeps the oven	degrees warmer than the actual Probe
		Temperature.		must be used with the Probe Temperature.

PROGRAM NUMBER

PROG. — Recalls and displays the cooking programs, by number, beginning with 00. DOWN — Decreases the Program Number (range is 00 – 98).

UP — Increases the Program Number (range is 00 – 98).

ENTER — Stores the cooking parameters (up to 5 Phases) in memory under the Program Number. Cooking parameters will not be lost during power outage or disconnection.

FAN SPEED — Push once for Half Speed (light is on); push twice for Full Speed (light is off). HUMIDIFIER — Sprays a little water into the oven while button is pushed. Makes steam if oven is hot.

– 11 –