CONFIGURATION MODE — PROGRAMMABLE CONTROL
WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY FROM THE OVEN AND PLACE A TAG AT THE DISCONNECT SWITCH INDICATING THAT THE CIRCUIT IS BEING WORKED ON.
Identify the manufacturer(s) of the convection fan motor(s) by inspecting the label on the motor(s) after the rear panel is removed. This information is needed for Steps 9 – 11. Replace rear panel and reconnect electrical power.
Some of the procedures in this section are set at the factory and do not need to be
CF
Pressing repeatedly
advances through each step 1 through 12 and then repeats from step 2.
After any keystroke where an individual setting is
either changed or accepted, the setting will display for three seconds and then automatically advances to the next step.
1. Configuration Mode can be entered only when the oven is OFF. With
the oven OFF, press and the UP and DOWN arrows in the TIME area all at the same time for about three seconds. [ Conf ] will be displayed in the temperature display to indicate Configuration Mode.
Press to begin.
2.[ C F ] will be displayed in the TIME display to allow selection of the temperature scale. Press the UP arrow key for Fahrenheit. The DOWN arrow key is used for Celsius. A blinking F indicates Fahrenheit is selected while a blinking C would indicate Celsius. After making a
selection, the selection displays for three seconds and automatically
advances to the next step. Or, press to advance to the next step.
3.[dSC ] is displayed in the TIME display and the number of clean cycles completed is displayed in the TEMPERATURE display. This number
cannot be changed or modified. Press | to advance to the next |
step. |
|
4.The revision level of the control's software is displayed in the time
display and cannot be changed. This information is needed by your
service technician. Press to advance to the next step.
5.[ HHH ] is displayed in the TIME display and the total cooking hours of the oven is displayed in the temperature display. This can be reset. Using the UP arrow key in the temperature display will increase the
number of hours; using the DOWN arrow key will decrease the number
of hours. Press to advance to the next step.
6.[ bbb ] is displayed in the TIME display and the buzzer is sounding to indicate the buzzer's
or decrease the numeric value to obtain the desired sound. Buzzer
loudness can be adjusted by your service technician. Press to advance to the next step.
– 36 –