Azden IRH15C Index, Important Safety Instructions, Specification, IRR-15/IRR-30Receiver, IRH-15c

Index

Page	Subject
2	Important Safety Instructions
3	Handling care for Ni-MH battery
4	Introduction
5	Feature
6	System configuration, Installation case beside Plasma Display Monitor
7	IRR-30 Receiver set up
8	IRR-15 Receiver set up
9	IRB-10c Transmitter

10IRN-10 Transmitter

11IRH-15c Handheld Microphone

12IRD-10/20/60 External Sensor

13Trouble shooting

13Microphone suggestions, Regulation

14Specification

Important Safety Instructions

1.Read these instructions for use.

2.Keep these instructions in a safe place.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use near water.

6.Clean only with a dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.

8.Do not install near any heat sources such as central heating radiators, electric heaters, stoves, or other units that produce heat (e.g. amplifiers).

9.Only use attachments/accessories specified by the manufacturer.

10.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the unit. When a cart is used, use caution when moving the cart/unit combination to avoid injury from tip-over.

11.Unplug during lightning storms or when unused for long periods of time.

12.Refer all servicing to qualified service personnel. Servicing is required if the unit has been damaged in any way, such as mains cable or plug damage, liquid has been spilled, objects have fallen inside, the unit has been exposed to rain or moisture, does not operate properly or has been dropped.

2

Specification

IRR-15/IRR-30 Receiver

Sub-carrier Frequency	2.06MHz&2.56MHz IRR-15: 1CH IRR-30:2CH
Type	Super Heterodyne-Crystal Controlled
Modulation	FM
S/N Ratio	More than 90dB
Reception Sensitivity	More than 25dBμV
Audio Output Adjustment	Mic:-20dB maxLine: 0dB max
Audio Output Impedance	Mic:Less than 1.5kΩLine: Less than 1kΩ
Power Requirement	12V DC 350mA
Size	100(W) x 161(D) x 44(H)mm (IRR-15)
	215(W) x 210(D) x 44(H)mm (IRR-30)
Weight	530g (IRR-15)
	1.15kg(IRR-30)
IRH-15c
Sub-carrier Frequency	2.06MHz&2.56MHz Switchable
Modulation	FM
Microphone Element Type	Uni Directional Dynamic
Battery Type	2-"AA" Alkaline (1.5V x 2)
	2-"AA" rechargable Ni-MH or Ni-Cd(1.2 x 2)
Battery Life	>8hours w/alkaline batteries -low power mode
	>5hours w/alkaline batteries -high power mode
Size	240 x 58mm
Weight	300g w/alkaline batteries
IRB-10c
Sub-carrier Frequency	2.06MHz&2.56MHz Switchable
Modulation	FM
Microphone Element Type	Electret Condenser
Frequency Response	50-10kHz ±3dB
Battery Type	2-"AA" Alkaline (1.5V x 2)
	2-"AA" rechargable Ni-MH or Ni-Cd(1.2 x 2)
Battery Life	>10hours w/alkaline batteries -low power mode
	>8hours w/alkaline batteries -high power mode
Size	100(H) x 64(W) x 27(D)mm
Weight	140g w/alkalaine batteries
IRN-10
Sub-carrier frequencies	2.06MHz or 2.56MHz
Modulation	FM
Microphone element type	Uni-directional electret x 2
Frequency response	50-9kHz ±3dB
Ext Mic Input Jack	3.5mm
Battery type	2-"AA" Alkaline (1.5V x 2)
	2-"AA" rechargeable Ni-MH or Ni-Cd(1.2 x 2)
Battery life	>10hours w/alkaline batteries- low power mode
	>8hours w/alkaline batteries- high power mode
Size	80(H)x70(W)x27(D)mm
Weight	120g- Transmitter w/alkaline batteries
IRD-10/30/IRD-60	62g Transmitter w/o alkaline batteries
Output	F-Connector(IRD-30/60) / RCA-Connector(IRD-10)
Power	Powered by reciever (24V 10mA)
Size	52(W)x27(H)x73(D)mm (IRD-10)
	72.5(W)×27(H)×50(D)mm (IRD-30)
	100×30mm (IRD-60)
Weight	210g Included 10m cable and bracket(IRD-10)
	90g Included mounting bracket (IRD-30)
	170g Include mounting bracket (IRD-60)
	15