Azden IRH15C The IRD-10/30/60External Sensor, Feature, Guide for sensor installation

The IRD-10/30/60 External Sensor

To increase the working range of the system, up to three external sensors can beadded. External sensors are powered by the receiver and can be plugged into the "EXT.SENSOR INPUTS" (9) on the rear panel. Plugging into inputs 1 and/or 2 (9) adds to the built-in front sensor (3) and extends the working range by 15m with IRD-10, 15m in straight direction with IRD-30 and 15m half- diameter range in 360 degree.

Plugging into input 3 (9) automatically disconnects the front panel sensor. Thisway, if the front panel sensor is blocked (perhaps in a secured cabinet or closet) it canbe replaced.

Guide for sensor installation		Vending point	Attached screws for wood wall
IRD-10
Fix the installing bracket
by screws firmly.
			Holes for screwing
	1, The black color side should face the near side when fixing the bracket.
	Vend the bracket 90 degree to front.
	2, Fix screws
	Screw pitch: 30mm and 24mm Black color side
	3, Slide the sensor unit for hooking up to the bracket.
	Adjusting the angle of the bracket for sliding the sensor much easily.
		Bracket	IRD-10 sensor

Wall

Emitter

The microphone emitter and sensor top surface face vertically is best position. Adjust the angle for suitable angle.

Feature

Receiver

◆New circuit design for minimizing the interference with the Plasma display.

◆New method for eliminating the strident noise.

◆Don't get interference by other generally used wireless method like UHF and VHF. At the same location, even adjacent rooms, same package can be used without any interference.

◆Internal sensor can cover an open area up to 144 square meter under transmitter high power mode and 108 square meter with Lo mode.

◆Up to max. three external sensors can be extended depends on size of room. Three type sensors are available as option item.

◆Azden Newly designed state-of-the-art Crystal Servo technology for frequency-stable transmitting

Sensor

◆One is IRD-10 ,which can fly to 10m distance on the line of sight. IRD-30, which can cover up / down and right / left side 120 degree up to 15m in straight direction, and IRD-60 called "Dome sensor" can cover 360 degree area reception up to 15m half-diameter.

Microphone/Transmitter

◆Three type of microphones, handheld, pendant and table top, are available depends on users' needs.

◆Handheld microphone IRH-15c utilize two emitters at bottom and top for transmitting audio in all around 360 degree direction. Up to 20m distance in line of sight can fly constantly.

◆High and low switch for selection of emitting power depends on the size of location and for extending the life of battery.

◆Two channel setting on IRH-15c,IRB-10c and IRN-10 can be switched to either channel on the spot by just sliding switch.

◆IRB-10c allow speakers for hands free action thanks to pendant or body clip wearing. Use IRN-10 if the speakers are installed on the ceiling by adjusting the mic gain.

IRD-30/IRD-60 Installation

IRD-30 Sensor covering area:

Up and down direction and both side, each120 degree

Covering 120 degree

30m is covering distance in frontside

IRD-60 Sensor covering area

15m is covering distance in frontside

360 degree

Connection cable is not attached as standard items. Buy coaxial cable 3C-2V or 5C-2V.

12 5