Chapter 3: Software Driver Installation
Windows 95 or 98
The 3PCIO1 drivers are unique to this series of cards. If at some point in the future you want to update these drivers, remove these drivers before installing the new version. See Removal at page 16.
Windows 98 screens are shown for this section. Windows 95 will have other screen names and text shown.
1.Configure the jumpers on card and install it – see Chapter 2.
2.Make sure PnP OS is set in the BIOS. Power up the computer.
3.Windows will detect the PCI card, start the Add New Hardware Wizard, and begin driver installation.
4.The driver installation goes through several steps, after finding the driver files. The first part installs the driver for the card, then after Finish, the second part installs the serial driver for the Com port. Do not remove the disc until completed.
5. Click Next.
8 | Chapter 3 | Documentation Number |
B&B Electronics Mfg Co – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph
