adjust Zone 1 (A) ID to desired valueVOLUME KNOB
(REW) or(FF)
2
move to Zone ID
∧ (UP) or ∨ (DOWN)
(PAUSE) or (STOP)
1
ActionFrom Front PanelFrom Remote
Set Zone 1 (A) On Screen display usage - During normal operation, when you make a change to a system
setting or your receiver detects a change to the incoming audio or video, a message is overlaid along the bottom
of your video screen. You can turn off the overlay display from this menu. This will not affect the on-screen
displays when you enter the menu system.
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Sreen Dis
p
la
y
Enabled
4 V1 Out
p
ut Ta
p
e
5 Surround Modes Auto
next item ad
j
ust
MENU advanced setu
p
3 On Sreen Dis
p
la
y
Enabled
set to Enabled or DisabledVOLUME KNOB
(REW) or(FF)
2
move to On Screen Display
∧ (UP) or ∨ (DOWN)
(PAUSE) or (STOP)
1
ActionFrom Front PanelFrom Remote
Set V1 line output usage - V1 output is normally set up as a tape loop. The V1 and Zone 1 (A) output are the
current source (V2, TV, CD, DVD, etc.) except when the current selection is V1. When V1 is selected as the
source, the Zone 1 (A) output is V1 and the V1 output is off. This prevents feedback when the V1 inputs and
outputs are connected to a tape deck or VCR. Feedback can cause high frequency oscillations which may
damage your speak ers. If you don’t connect a tape dec k to the V1 input and output you can use the V1 output as
an additional line out. In this mode V1 output is always the selected input inc luding V1. Note: The T ape input and
output is always set up as a tape monitor for Zone 1 (A).
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Sreen Dis
p
la
y
Enabled
4 V1 Out
p
ut Ta
p
e
5 Surround Modes Auto
next item ad
j
ust
MENU advanced setu
p
4 V1 Out
p
ut Ta
p
e
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Sreen Displa
y
Enabled
4 V1 Output Line
5 Surround Modes Auto
WARNING Connectin
g
a tape
recorder to V1 in LINE mode
can cause speaker dama
g
e
next item ad
j
ust
MENU advanced setup
4 V1 Output Line
set for Tape or LineVOLUME KNOB
(REW) or(FF)
2
move to V1 Output
∧ (UP) or ∨ (DOWN)
(PAUSE) or (STOP)
1
ActionFrom Front PanelFrom Remote
63 p/n 12858 Rev. 0717A