13258 11/01
53
Select variable ‘EQ 1’ - to allow separate bass and treble settings for use with all input sources.
Many systems allow only adjustment of bass and treble levels at fixed frequency points . Your processor allo ws
you to adjust level and frequency so you may fine tune your tone controls to proved either very subtle effects at
just the right frequency extremes, or for more a pronounced effect at higher bass and lower treble frequencies.
A default setting for bass and treble may be set under Setup Room Equalization.
Selecting variable ‘EQ 1’ allows you to use the options shown below in VARIABL E EQUALIZATION, and
temporarily override the default settings made to bass and treble in setup room equalizatio n (See Room
Equalization under Setup Speakers).
Adjust LFE Level if you have no subwoofer and you wish to reduce the low frequency effects ( LFE) channel to
lessen its contribution to the bass going to your remaining large sp eakers. Or, even with a subwoofer, you m ay
just wish to reduce the overall LFE level, especially in an apartment situation. Note th at this affects only the
separate LFE (.1) channel available on Dolby Digital and DTS material it has no effect on the repr oduction of
normal bass from the front, center, or surround channels.
Select DTS LFE MODE Music if your DTS material is mixed for a reduced LFE s etting and you wish t o have a
more natural sound. Note that this affects only the separate LF E (.1) channel availab le on DTS m aterial and h as
no effect on the reproduction of normal bass from the front, center, or surro und channels.
Select Dynamic Range Limited for late night listening while using Dolby Digital bit streams and a reduced
dynamic range is desired. When the dynamic range is set to limited, com pression is used to raise the aver age
loudness of the dialog, and the program peaks will be restricted much in t he style of conventional television audio.
From Remote
From Front Panel
Action
1
EQ then 1 not available select VARIABLE EQUALIZATION
2
SEL or ENTER ↵ (ENTER) enable VARIABLE EQUALIZATION
3
(PAUSE) or (STOP)
X(REW) orW(FF)
(UP) or (DOWN)
VOLUME KNOB select and adjust desired parameters
3
MENU MENU return to Zone 1 (A) operation
VARIABLE EQUALIZATION
Frequency Level
Bass 100.0 Hz 0.0 dB
Treble 10.0 kHz 0.0 dB
LFE Level 0.0 dB
DTS LFE Mode Movie
Dynamic Range Normal
next item adjust
MENU zone operation
↑ ↓ ← →