
13258 11/01
54
Select loudness ‘EQ 2’ - sets the equalizer to use preset filter curves designed for use when using low listening
levels. The human ear’s frequency response varies with volum e level. At high levels it has relatively flat response,
while at low levels its sensitivity to high and low frequencies is reduced. The loudness equalizer is designed to
cancel the ear’s frequency response anomalies to provide consistent tone at all volum e levels. Note that you will
hear little difference using the loudness control at high volum es as it has its greatest effect at lower volume levels.
Select theater EQ ‘EQ 3’ - sets the equalizer for use wit h a preset filter curve best suited for sm all home
theaters. Many soundtracks are mixed for a large movie theater with v er y absorp tive s urf aces and speak ers firing
through projection screens. If the soundtrack has not been adjusted for home use, it ma y sound overly bright or
harsh. Theater EQ allows you to apply preset high frequency compensation specificall y set for use with this type
of material.
ZONE ‘Z’ Use the Z (zone) function via the remote control - Your processor comes equipped with a fully independent 2-
channel analog pre-amp for use with a second audio zone. The easiest way to c ontrol the seco nd Zone is with a
dedicated Z2 remote available from B&K and other univers al remote suppli ers. You can als o control the s econd
zone from your zone 1 remote via the “Z” button.
From Remote From Front Panel Action
1
B&K See Zone 2 (A) operation make sure remote is in B&K mode
2
Z See Zone 2 (A) operation select alternate zone control
3
2 See Zone 2 (A) operation select desired zone
Normally, your second zone will be zone 2. However, it is possible to change the zone ID (see Advanced
settings). If the second zone (zone B) ID has been changed, enter its current ID here to get control of the second
zone. If the zone ID is 10 or larger hit +10 followed by the second digit to gain control.
After a few seconds of inactivity, control will automatically revert t o zon e 1 (A). If you do n’t wish t o wait, jus t pres s
Z then 1. You can also control zone 2 (B) from the remote or front panel via the menu system. Ref er to ZONE 2
(B) OPERATION.
Control Zone 2
+10 0-9 to select zone