
13258 11/01
75
From Remote From Front Panel Action
1
(PAUSE) or (STOP) (UP) or (DOWN) move to Update
2
X(REW) orW(FF) VOLUME KNOB select Enable or Disabled
RS-232 receive ID -
From Remote From Front Panel Action
1
(PAUSE) or (STOP) (UP) or (DOWN) move to Receive ID
2
X(REW) orW(FF) VOLUME KNOB select desired receive ID
RS-232 transmit ID -
From Remote From Front Panel Action
1
(PAUSE) or (STOP) (UP) or (DOWN) move to Transmit ID
2
X(REW) orW(FF) VOLUME KNOB select desired transmit ID
3
MENU MENU return to ADVANCED SYSTEM SETUP
4
MENU MENU return to SYSTEM SETUP
5
MENU MENU return to MAIN MENU
After completing all of your advanced settings you may wish to backup the settings. Refer to Memory
Backup/Restore under the MAIN MENU or see the Setup section of this m anual
FACTORY RESET Should you ever need to completely reset the processor to the original factor y settings f rom the front panel press
the SLEEP, DOWN, and MENU buttons simultaneously. The processor will perform a complete reset and
erase all user-programmed presets, menu settings, and the memory backup if you hav e performed one.
RS-232 PORT SETUP
1 Port Enable
2 Baud Rate 9600
3 Echo Enable
4 Update Enable
5 Receive ID 0
6 Transmit ID 0
next item SEL select
MENU advanced setup
5 Receive ID 0
RS-232 PORT SETUP
1 Port Enable
2 Baud Rate 9600
3 Echo Enable
4 Update Enable
5 Receive ID 0
6 Transmit ID 0
move to new line
next item SEL select
MENU advanced setup
6 Transmit ID 0