Automatic Lift Fryer | Operation |
|
|
Start-Up
1.Make sure the main drain valve is closed.
2.Fill pot with shortening to about one inch below the mark.
Risk of fire exists if the oil level drops below the minimum oil level. The level of oil within the pot must not fall below 5mm of the maximum oil level.
Use of oil/shortening older than the manufacturers recommendations for life of the oil is prone to surge boiling and flash fires. Follow the oil manufacturers guidelines for lifecycle of oil/shortening.
Overfilling the fryer pot with shortening could lead to serious injury. Ensure that the fryer pot is filled with shortening only to the fill mark when shortening is hot. Do not use any shortening other than what is specified in this manual and do not overfill the fryer pot.
The fryer has a maximum temperature setting of 375º F/190º C (for ALF and
Use only
3.Place the FILTER/OFF/FRY switch to the FRY position. The question “Is the Fry Pot filled – If yes press ENTER” will appear on the computer display. The shortening will heat and begin to reach the fill mark inside the pot.
4.Add more shortening as required to reach the fill mark. Once the oil reaches the fill mark, press the ENTER button. The computer will display “STIR OIL” and automatically enter the STIR OIL mode. In this mode the computer will heat the oil to 255°F and hold that temperature.
5.Stir the oil freely while it is heating. Press the 0 button when finished stirring the oil.
IMPORTANT! Before the first cooking operation each day, stir the shortening freely while it is heating to provide a balanced shortening temperature for excellent results with the first cooking. Failure to do this can result in a crusty skin on the product surface with an undercooked product internally. In addition, in some cases, failure to stir the shortening while it is initially heating may cause the
Cooking
1.Ensure that the
2.Press the desired program number on the keypad. The computer will still display "LOW". The fryer will begin to heat to the temperature that has been factory preset. When "READY" appears on the display, the fryer is up to the desired temperature and the product can be loaded.
3.When frying chicken, lower the basket into the shortening by depressing the basket switch to the DOWN position.
Hot shortening may splash out of the pot causing severe injury when dropping chicken into pot. Carefully drop pieces of chicken into pot to prevent shortening splashes.
22
