Bakers Pride Oven CB-MVPWDS manual Cleaning The Blower Wheel, D. Servicing

Figure 1 Cleaning The Blower Wheel

Blower Wheel

Set Screws (2)

Wheel Puller Bolt 3/8”-Hex Motor

D. SERVICING:

NOTE: THIS APPLIANCE MUST BE SERVICED BYAN AUTHORIZED SERVICE AGENT.

(1)Power supply to the unit must be disconnected before any service is performed.

(2)Most of the service on the unit can be performed from the front and/or control panel side.

(3)For proper servicing, access to the control panel side of the unit will be required.

(4)It will be necessary to have access to the back of the oven for service needs related to the electric power supply.

(5)A system wiring diagram is provided in this manual and on the back of the service panel on the right side of the oven.

(6)All servicing should be performed by a factory-authorized technician only.

(7)For proper maintenance and repairs, call the factory toll free (800-972-6887) for an authorized service agency in your area.

!	WARNING: RISK OF FIRE. When stacked two high maximum, use stacking kit	!
	part # E3771A only.
!	CAUTION: This product, when stacked, has more than one power-supply	!
	connection point. Disconnect all power supplies before servicing.
Figure 2	OPEN RACK STAND ASSEMBLY INSTRUCTIONS: COB-E & COM-E

770504		Oven Base
Lock Nut 1/4-20 (12)
8507600
Washer, Flat 1/4" (12)
8205500
Screw, 1/4-20 X ½ (12)
	21818222
21816807
		Support, Lt Open Rack (2)
Support, Wire Rack (2)

770504

Lock Nut 1/4-20 (12)

21818234 Undershelf, Gas Oven (1)

Open Style Support Leg

8205500 Screw, 1/4-20 X ½ (12)

Assembly Instructions

1:Place undershelf between legs & secure with ¼-20 UNC screw, flat washer & locknut. The holes for mounting the wire racks should be toward the front of the oven.

2:Place open rack supports between legs and secure with ¼-20 UNC screw, flat washer and locknut.

3:Slide open wire racks into position using the holes in the undershelf as a guide.

8