Gas Pressure Fryer | Operation |
Item Description
1Pressure Gauge
2Spin Handle
3Pop Safety Valve lever
4Computer
5Rocker Switch
6Thermostat Knob
7Thermostat Light
8Digital Timer
LED indicator
TIME SELECT (2 arrow buttons)
START/STOP button
ALARM button
Function
Indicates the pressure inside the pot.
Used to tighten the lid to the pot once it is latched.
Used to release pressure periodically to prevent the seat from sticking. Used to set and activate product programs.
FILTER – When placed in this position, power is applied to the motor and shorting is pumped into the pot directly or thru the fill hose.
OFF – When placed in this position, power is removed from both the pump motor and gas system.
FRY – When placed in this position, power is supplied to the thermostat and gas system.
Used to set the temperature of the shortening.
Illuminates when the thermostat calls for heat. Extinguishes when the shortening temperature is reached.
The digital timer consists of an LED, display, beeper and 8 buttons described below:
Prior to the start of a timing cycle the LED will be OFF. When running a timing cycle the LED will flash. At the end of a timing cycle the LED will turn ON steady. When idle the LED is off.
Two arrow buttons on the front panel are used to set the time. Hold the UP ARROW button down to increase the time. The longer the button is held down, the faster the rate at which the time will increase. The DOWN ARROW button is used in the same manner as the UP ARROW button except it will cause the time to decrease. The time is increased or decreased in
Starting the Timer - Pressing this button while the timer is not active will cause the timer to begin counting down the time on the display. Stopping the Timer - Pressing this button while the timer is active will stop the timer from counting down and display the remaining time. Time cannot be changed with the TIME SELECT buttons at this point. If this button is pressed again the timer will continue counting down from the point it was stopped.
Resetting the Timer - Pressing and holding this button for longer than two
(2)seconds will reset the timer and the display will return to the original starting time. At this point, time can be changed using the TIME SELECT buttons or the preset buttons.
Canceling The STIR OIL Function - Pressing this button cancels the STIR OIL function while it is active.
This button allows the user to set an elapsed time at which the internal alarm will sound during a cycle. The time is set by pressing and holding the ALARM button while using the UP and DOWN arrows to change the time. The controller will limit the alarm time to be less than the currently programmed interval cycle time. The default alarm time is 0:00 which disables it. The ALARM time is saved on power down in the same manner as the last interval time. When a time cycle is running and the alarm time has elapsed the internal alarm will sound for 10 seconds. For example, a cycle time 10:00 and alarm time of 2:00 would cause the alarm to sound for 10 seconds once the controller has counted down from 10:00 to 8:00. This button is used to cancel the STIR OIL alarm. This button is also used to reconfigure the STIR OIL Function.
13
