Bakers Pride Oven WDCG, SSWG Front and Rear Cover Attachment, Pedestal Model - End Panel Mounting

Hot Food Deli Case Installation

7.Proceed in the same manner until all the cases in the line are level and bolted together.

8.Complete the line up by slipping the Counter Top Joint Cover over the ends flanges of the adjoining counter tops.

Front and Rear Cover Attachment

1.Slide the Rear Cover over the Pedestal Frame first (see Figure 3). Then slide the Front Cover over the Frame with the sides of the Front Cover lapping over the side of the Rear Cover. The Front Cover will extend approximately 4-1/2” from the front of the frame.

2.Drill two 5/32” diameter holes in each side of the Pedestal Frame to match the predrilled holes in the covers.

3.Secure the covers to the frame using the #8 sheet metal screws provided.

4.These cases are to be sealed to the floor if required by local health codes. Seal the pedestal covers to the floor using a silicone-type sealant (Dow Corning RTV #732 or equivalent).

End Panel Mounting

Figure 4. Pedestal Model - End Panel Mounting

1.Attach the End Panels to the ends of the case(s) as shown in Figure 4 using the shoulder screws provided.

For Glass End Panels only, slide the plastic bushings provided over the shoulder screws before inserting the screw into the glass panel. Be careful that the screws do not bind in the holes in the glass panel.

13